Dry cleaning of clothes is prone to four common accidents

The basic steps of laundry dry cleaning, pretreatment, that is, stain removal treatment. It is the artificial pretreatment of heavy soils and stains that are insoluble in dry cleaning solvents (such as juice, nail polish, paint, ink, etc.) with artificial additives. The second step, the main wash. The pretreated laundry is placed in a dry cleaner, washed with a dry cleaning solvent and spin (dry) dry. The third step, post-processing, the important goal is to remove the residual dry cleaning solvent in the clothes and ironing and shaping. Some common faults in the dry cleaning process and how to deal with them Incident 1: Why are the buttons more and more broken? Dry cleaning was performed according to the instructions on the Care label. Cause: The plastic used for the button cannot withstand the repeated impact force with the cage wall during the normal dry cleaning cycle. Obligation: There is no warning mark on the maintenance label, so the responsibility is borne by the manufacturer. If there is a horizontal line on the maintenance label, the dry cleaning personnel should bear the responsibility. Incident Two: Black Beads Dissolved Problem: When a purple garment made of glitter acetate was dry cleaned in perc four times per label instructions, the black beads softened and melted, leaving only the The black stains on the face, the whole clothes have such stains. Cause: This ornament cannot be washed by perchloroethylene, and it will dissolve only if it is immersed in perchloroethylene for 2 minutes. The description of the Yiyang label is based on expectations, and it is not difficult to verify its correctness. Obligation: It should be borne by the manufacturer, but has no choice but to restore it. Incident 3: Problems with metal ornaments Problem: A metal ornament with a fabric around the neck appears to shrink and wrinkle after dry cleaning. Cause: If the decoration is composed of different fibers, it is important to consider the shrinkage rate of each layer so that the decoration is still flat and clean after dry cleaning. Obligation: It is borne by the clothing manufacturer, because he obviously does not have strict operating standards and quality control standards. Fix: Sometimes this error can be corrected. Usually, the wrinkled area is soaked with water, and then ironed with steam. The pressure applied by each fiber layer must be uniform, so that it can be flat after dehumidification. Incident Four: The Coated Collar Cracked Problem: The collar of a jacket was urethane coated. After dry cleaning, most of the collar coating resisted dry cleaning, but the coating showed cracks and peeling along the fold of the collar. Cause: The fibers with the coating will twist when the clothes are deformed, and small cracks will appear in the places where the folds and twists are more severe. Before washing, it is usually not easy to see, but after soaking with the washing solvent, the coating will be removed from the fibers. peel off. Obligation: After a period of deformed clothing, according to the instructions on the maintenance label, the clothes can be dry cleaned, so the responsibility lies with the manufacturer.