How to ironing after chemical fiber blended clothing appear dead plait - Music in Japan

This time we mainly answers about & other; How to ironing after chemical fiber blended clothing appear dead plait & throughout; The problem. First of all, to explain the problem belongs to the basic knowledge of washing, on the surface, the question before ironing workers, but in essence, the root of the problem is that the washing.

how ironing after chemical fiber blended clothing appear dead plait

if the problem from the aspects of ironing to solve is conditional. In other words, not all dead plait can iron clothes, only one part of a fold wrinkles in clothes can not death. In addition, you can use the groove flat ironing machine or smooth clip machine for ironing clothes is the basic for recovery. If use manual must be used for pressing iron, but the ironing temperature is relatively difficult to master.

groove flat ironing machine for ironing high temperature, high pressure, so to solve this problem. In the use of smooth machine, steam pressure should guarantee at 0. More than 4 mpa, press time should be extended appropriately at the same time, to ensure that the fiber fully soften and to finalize the design. Even so, the next time after wash, most of the dead plait is apparent.

the method to solve the problem is fundamentally eliminate the drape of clothing. The specific method is to appear fold the clothes into the washing machine again, installed capacity not greater than 1/2 of the machine capacity in order to make the clothing fully unfolded. Water level to the basic before loading. When the steam when heated up to high level, if is a washing machine, the use of electric heating water to add directly to the high level. Is the 1/3 of normal washing detergent quantity, the heating temperature than the last time the plait of washing temperature, that is, if the original is 70 ℃ fold, when dealing with the temperature of 75 ℃ ~ 80 ℃, so that obtain from the fold, softening and recovery.

in the whole process, the washing machine should always be running state, don't stop halfway. When temperature meet the requirements after 15 minutes, so that the fabric softening, fold open fully, and then for cooling, this is the key to the success of treatment. Don't rush, the cooling speed slowly, do not add cold water for more than 3 seconds at a time, add cold water after running after 20 seconds (1 SEC on drainage Capacity of more than 50 kg models, work time should be extended appropriately) 。 So operation, the number of times unlimited, water until water temperature dropped to below 20 ℃, then add cold water to the whole level of 3/4 fully, at this time in uniform, dehydration, and then threw water twice over.

this cooling method also is suitable for chemical fiber blended cooling process after high temperature washing clothes. The characteristics of chemical fiber is similar to plastic, easy to soften and deformation when it is heated, dehydration of the centrifugal force is very strong, will have to soften the fiber extruding die plait, drowned in the injection of cold water to cool rapidly when setting, so the death of the formation of hate plait. Therefore, when washing chemical fiber blended clothing mostly use room temperature washing, it is to prevent death fold.